Each vehicle is thouroughly inspected

You might not worry much about the condition of your hose clamps or the vacuum system or the brake pads. You'll never have to, either, with one of our GM Certified Used Vehicles. Before they reach the sales floor, each one of our vehicles is meticulously looked over by a licensed mechanic. That means by the time you look at them, every single vehicle has passed our painstaking 150+ point inspection.

Vehicles are not eligible to be marketed as GM Certified Used Vehicles unless the dealer first performs all open safety, emissions and non-compliance recall repairs. GM has instructed us to check for open recalls and to perform all needed repairs before listing any vehicle as a GM Certified Used Vehicles. We determine whether there is an open recall on a vehicle by entering the Vehicle Identification Number at the GM Canada Recall Centre website recalls.gm.ca.

The 150+ point inspection includes:

Engine - 

Check the vehicle mileage against service records for accuracy.

ENGINE COMPARTMENT

Hood release, hinges, prop rod or gas struts provide proper operation.

Check finish (rust, corrosion).

ENGINE CONDITION & NOISE

Verify original equipment and displacement

Valve cover/cylinder head/exhaust manifold gaskets soundness

Condition of engine belts, automatic tensioner, hoses, wires and no squeaking belts

Condition of hose clamps, retainer clips, and wire casings

Look for areas of concentrated dirt or grime

Check for fluid leaks or valvetrain noise

Vacuum system condition

Fuel delivery system

ENGINE OIL LEVEL/CONDITION

Check engine oil level, verify oil clarity and viscosity.

ENGINE COOLANT LEVEL/CONDITION

Check radiator for leaks and damage/fan shroud is securely in place

Verify that blades of cooling fans are not broken or bent

Check coolant level, freeze protection rating

AIR FILTER INSPECTION

Inspect air filter/filter housing for debris (leaves, bugs).

BATTERY LOAD TEST

Inspect battery for cracks. Clean and inspect battery top, posts & cables

Measure battery voltage/conduct load test

IGNITION SYSTEM

Inspect system for loose, cracked or burned wires.

Check wire for short circuits and arcing

POWER STEERING FLUID LEVEL

Inspect power steering fluid level

BRAKE FLUID LEVEL

Locate and inspect master cylinder reservoir, check brake fluid level

AUTOMATIC TRANSMISSION FLUID LEVEL & CONDITION

Check all ranges from "Park" to "1st" for proper engagement.

FUEL SYSTEM

Inspect fuel injection system for proper operation

Check fuel system for leaks or loose wires and lines

Inspect evaporative emissions for proper operation

MANUAL TRANSMISSION FLUID LEVEL

Measure fluid level, clarity and viscosity (if equipped).

MANUAL TRANSMISSION HYDRAULIC CLUTCH FLUID LEVEL

Check clutch fluid reservoir for proper level.

WASHER FLUID LEVEL

Inspect/fill washer fluid reservoir (front)/(rear, if equipped).

STARTER PERFORMANCE (AUTOMATIC TRANSMISSION)

Check that starter only operates in "Park" or "Neutral".

STARTER PERFORMANCE (MANUAL TRANSMISSION)

Starts only when clutch pedal pressed all the way down (GM Vehicles).

 

Instrumentation & Interior Components Inspection -

OnStar® system - verify connection to OnStar® with blue button push

SRS system warning light/self test

ABS system warning light/self test

INSTRUMENT PANEL

Instrument panel/gauge lights and operation

Electronic instrument cluster, Head-up Display operational (if equipped)

CLIMATE CONTROL

HVAC/Front and Rear Electronic Climate Control (if equipped)

All climate control directional functions/vents working properly

Confirm Cabin Air Filter is clean

AUDIO/VIDEO SYSTEM

Audio controls, speakers, steering wheel controls (if equipped)

Power antenna (if equipped)

DVD player operational (if equipped)

Navigation system operational (if equipped)

Infotainment Systems verify operation of system with Multimedia Interface Tool (MIT Tool) , display screen, USB, Bluetooth, AUX jack,

etc., (if equipped)

WINDSHIELD WIPER/WASHER OPERATION

Front wiper/washer controls are operational

Front wiper blades

Rear wiper/washer controls are operational (if equipped)

Rear wiper blade (if equipped)

ELECTRIC REAR WINDOW DEFROSTER OPERATION

Defroster switch/heating grid operation

HORN OPERATION

Horn operation/sound quality

LIGHTER/POWERPOINT OUTLETS

Cigarette lighter, USB, AUX, powerpoints operational

TILT STEERING WHEEL (IF EQUIPPED)

Steering wheel locks in each tilt position

Confirm operation of heated steering wheel (if equipped)

INSIDE REARVIEW MIRROR

Rearview mirror adj., range of movement, Auto dim (if equipped)

Map/Reading lights (if equipped)

WINDOWS

Power windows and controls are operational (if equipped)

Sliding rear window/vent windows (if equipped)

OUTSIDE MIRROR CONTROLS

Check mirrors for full movement in all directions

Inspect mirrors for clarity, scratches or cracks

Heated Mirrors/Personal Memory systems function (if equipped)

 POWER SUNROOF OPERATION (IF EQUIPPED)

Sunroof opens, tilts and closes properly

Check sunroof track for any obstructions or damage

Check sunroof seals for any cracks or damage

REMOVABLE ROOF PANELS (IF EQUIPPED)

Roof panel latches

Check roof panel weather stripping for cracks or damage

CONVERTIBLE TOP OPERATION (IF EQUIPPED)

Headliner condition (if equipped)

Check roof structure for bent rods or damage

Top opens and closes fully

Rear window, glass or plastic condition

Convertible top seals and clamps

 

Interior Trim Inspection -

SEAT FABRIC AND TRIM CONDITION

Inspect vehicle seats for wear, stains or tears

Passenger compartment trim panels fit and finish

Headliner fit and condition

SEAT ADJUSTMENT

Driver and Passenger seat tracks are operational

Adjustable head restraints (if equipped)

Folding rear seatback/Valet Lockout feature (if equipped)

Driver/passenger/rear seat controls are operational

SAFETY BELT CONDITION/INTEGRAL CHILD SEAT OPERATION

All seat belts are operational

Inspect safety belt webbing and buckles at all seating positions

Height adjustable shoulder belts work correctly (if equipped)

Check that integral child seat is operating properly (if equipped)

Inspect all child seat hardware and latches

SUN VISOR OPERATION AND CONDITION

Sun visors are operational

INTERIOR/COURTESY LIGHT OPERATION

Check that all interior lights/switches are operational

REMOTE DECKLID/LIFTGATE RELEASE OPERATION

Check operation of decklid/liftgate during remote release

Inspect weather seal for damage

Decklid pull down feature (if equipped)

REMOTE FUEL FILLER DOOR RELEASE OPERATION (IF EQUIPPED)

Inspect operation of the remote fuel filler door release feature

Interior fuel door switch, release mechanism working properly

Confirm capless fuel filler is intact and working correctly

ASHTRAY

Inspect ashtray for broken, bent, or melted components

GLOVE BOX OPERATION

Inspect latch, lock, and hinges for proper operation

DOOR TRIM AND LOCK OPERATION

Check that all doors open and close smoothly

Inspect operation manual or power door locks, rear door security lock

Check that doors cannot be opened in the “Locked” position

Check hand held remote transmitter operational (if equipped)

Check all interior/exterior door handles for damage

Check and confirm child door lock operation

Inspect fit and finish of each door trim panel, armrest, assist strap

CARPET AND FLOOR MAT CONDITION

Inspect carpet and floor mats for burns, dirt, excessive wear

CARGO AREA

Inspect cargo area trim panels for fit and finish

Cargo area, door lock switch operation, powerpoint power (if equipped)

SPARE TIRE CONDITION/JACK & WRENCH LOCATION

Inspect spare tire and wheel condition

Inspect that all tools needed for spare tire change are intact, or if

equipped with spare tire delete, the fill kit is available

 

Pre-Test Drive Inspection

HEAD LAMP/FOG LAMP OPERATIONS

Headlamp switch, High/Low beam is functional

Headlamps are aimed properly

Twilight/headlamp delay feature OK (if equipped)

Fog lamps are aimed and functional (if equipped)

PARKING/BRAKE/BACK UP/TURN & SIDE MARKER LAMPS

Front and rear parking lamps

Brake and backup lamps

Left/Right turn signal lamps

HAZARD WARNING LIGHTS

Hazard warning lights work with vehicle running/not running

WHEEL AND TIRE CONDITION

(INSPECT PRE TEST DRIVE AND IN SERVICE BAY)

Tires meet 4/32” minimum requirement

Tire build dates (DOTs) within 6 years

Wheel covers/wheel centre hubs OK (if equipped)

Tire side walls, valve stems, and wear pattern

Tire size/correct air pressure/lug nuts secured

Inspect wheel rims for damage

SHOCK ABSORBER TEST

Front shock absorbers/strut assembly

Rear shock absorbers/strut assembly

 

The Test Drive

BRAKE SHIFT/TRANSMISSION INTERLOCK

(AUTOMATIC TRANSMISSION)

Gear selector cannot be moved out of Park unless brake is applied

TRANSMISSION OPERATION (AUTOMATIC)

Transmission gear engagement/shift points are smooth

TRANSMISSION OPERATION (MANUAL)

Clutch pedal/gear shift engagement

Inspect transmission for noise

 

ENGINE PERFORMANCE

Engine driveability/performance

BRAKE OPERATION

Power assisted braking system is functional

Rear parking assistance monitor operational (if equipped)

Anti-lock brake system warning/self-test light is functional

Anti-lock brake system functional (if equipped)

Vehicle tracks straight under hard braking conditions

SUSPENSION/DRIVETRAIN/NOISE

VIBRATION HARSHNESS

Inspect for abnormal vehicle noise, windnoise, vibrations or harshness

 CORNERING ABILITY

Vehicle cornering dynamics

Inspect for vehicle abnormal body roll

CRUISE CONTROL (IF EQUIPPED)

Cruise control holds a set speed/adjustments work properly

 

Active Safety Test/Inspect If Equipped

BRAKE SHIFT/TRANSMISSION INTERLOCK

(AUTOMATIC TRANSMISSION)

Gear selector cannot be moved out of Park unless brake is applied

TRANSMISSION OPERATION (AUTOMATIC)

Transmission gear engagement/shift points are smooth

TRANSMISSION OPERATION (MANUAL)

Clutch pedal/gear shift engagement

Inspect transmission for noise

ENGINE PERFORMANCE

Engine driveability/performance

BRAKE OPERATION

Power assisted braking system is functional

Rear parking assistance monitor operational (if equipped)

Anti-lock brake system warning/self-test light is functional

Anti-lock brake system functional (if equipped)

Vehicle tracks straight under hard braking conditions

SUSPENSION/DRIVETRAIN/NOISE

VIBRATION HARSHNESS

Inspect for abnormal vehicle noise, windnoise, vibrations or harshness

 CORNERING ABILITY

Vehicle cornering dynamics

Inspect for vehicle abnormal body roll

CRUISE CONTROL (IF EQUIPPED)

Cruise control holds a set speed/adjustments work properly

 

Service Bay Inspection

TRANSMISSION CASE INSPECTION

Transmission case/pan structurally sound

MANUAL TRANSMISSION FLUID LEVEL AND CONDITION

Fluid level, clarity and condition

TRANSFER CASE (4-WHEEL DRIVE AND AWD MODELS)

Fluid level, clarity and condition

Transfer case/skid plate structural condition

BRAKE SYSTEM CONDITION

Brake rotor/drum surfaces

Brake pads/shoes have 40% or more remaining pad life

Brake shoes have 40% or more remaining life

Parking brake operation

ENGINE MOUNTS/FRONT SUSPENSION LINKS & BUSHINGS

Inspect all engine mounts, grommets and bushings

Front suspension links/sway bar/mounts

STRUTS AND SHOCK ABSORBER CONDITION

Shock absorbers/struts free of leaks and damage

STEERING SYSTEM CONDITION

Inspect structural condition of all steering system elements

CV JOINT DUST BOOT CONDITION

CV dust cover boot void of rips/damage

DRIVE AXLE, AXLE FLUID LEVELS

Inspect differential case for fluid leaks

Front/Drive axle fluid level

FUEL TANK SYSTEM CONDITION

Fuel tank and delivery lines are sound, no fuel odour

VEHICLE/STRUCTURAL DAMAGE

Inspect for signs of collision damage

EXHAUST SYSTEM

Exhaust system hung/routed properly, meets structural integrity, exhaust tone

ENGINE OIL AND FILTER CHANGE, CHASSIS LUBE

Lubricate all chassis points, perform engine oil and filter change

 

Electric Vehicles - 

Confirm that the low voltage charger is operational and will charge the vehicle

Confirm that the vehicle can be charged with a level 2 charger

Confirm (if equipped) that the vehicle can be charged with the High Voltage DC charger

Exerior Wear & Tear Inspection

WINDOW GLASS

Inspect all glass surfaces for chips and cracks

HOOD CONDITION

Inspect hood for proper alignment with fenders, grille, and fascia

Inspect hood’s finish for dents and scratches

GRILLE, FRONT BUMPER, AND FASCIA CONDITION

Check that bumper guards and rubstrips are securely fastened

A Check grille, front bumper, or fascia alignment/condition

Vehicle is free from road tar and tree sap

DRIVER SIDE FENDER, DOOR(S), QUARTER PANEL CONDITION

Inspect for panel alignment, finish quality, previous body work

Weather seals, placement/condition

Bodyside mirrors, mouldings and badging properly secured

DECKLID, LIFTGATE, TAILGATE OR REAR CARGO DOOR CONDITION

Inspect the rear body panel surfaces for dings, dents and scratches

Decklid, liftgate or rear panel doors

Weather seals, placement/condition

Pickup tailgate/bed/side rails (if equipped)

Inspect bedliner

REAR BUMPER/FASCIA CONDITION

Inspect all rear trim components for proper fit, or collision damage

Check that all bumper guards and rubstrips are securely fastened

PASSENGER SIDE FENDER, DOOR(S) QUARTER PANEL CONDITION

Inspect areas for panel alignment, finish quality, or previous body work

Weather seals, placement/condition

Bodyside mirrors, mouldings and badging properly secured

ROAD ANTENNA

Inspect mast antenna, antenna secured

Final Inspections - 

Engine compartment is clean/degreased

Interior compartment has been cleaned

Vehicle exterior has been washed

Vehicles are not eligible to be marketed as Certified Used Vehicles unless the dealer first performs all open safety, emissions and non-compliance recall repairs. GM has instructed its dealers to check for open recalls and to perform all needed repairs before listing any vehicle as a Certified Used Vehicles . We are required to determine whether there is an open recall on a vehicle by entering the Vehicle Identification Number at the GM Canada Recall Centre website recalls.gm.ca.